DuraWood Single (NHDWR) and Double Rocker (NHDWDR)
*Footstool not included
Instruction #: 5079NH, 10.0M
The DuraWood Single or Double Rocker each comes in two boxes:
Single Rocker |
Double Rocker |
NHDWR+Color |
|
|
|
|
|
NHDWRARM |
|
|
|
The Hardware contains: |
The Hardware contains: |
|
|
Also needed for assembly are: |
Rubber Mallet or Hammer
One Ratchet with a size 7/16'' Socket
One Key with a size 7/16''
|
STEP 1
Do not tighten nuts until the last step. Fix one of the same two Uprights on the Arm using one 3.5" Hex bolt and one 5" Hex bolt. The Upright goes inside the Arm and the longer bolts afixes to the arms rest. Place the bolts facing outward. Right arm (when sitting) is shown. |
STEP 2
Put one of the same two outside Runners on the arm unit using two of the 3.5" Hex bolts. The Runner goes outside the Arm. Place the bolts facing inward. |
|
|
|
STEP 3
|
STEP 4 |
| We recommend putting all the bolts in before joining the parts together. Using the box as a support, put the arm on the rope body using three of the 3.5" Hex bolts. Repeat Step 1, 2 and 3 for the other side. |
Using four of the 5.5" Carriage bolts, unroll the Rope Body and afix to front of Uprights. |
|
|
|
If you have a Single Rocker. Skip to STEP 13.
| STEP 5 |
STEP 6 |
STEP 7 |
| Put the Back Legs on the Table using one 5" Hex bolt. |
Insert the Upright between both Legs of the Table using two of the 5" Hex bolt.. |
Insert the table unit on the chair.
|
|
 |
 |
| STEP 8 |
STEP 8 (follow up) |
STEP 9 |
| Insert a 5" Hex bolt under the chair. |
Attach the top of the chair with 2 of the Carriage bolts. |
Tilt the chair. |
|
|
|
| STEP 9 (follow up) |
STEP 10 |
STEP 11 |
| Turn the chair over |
Put the Front Legs on each side of the Table using three of the 5" Hex bolts. |
Put the Middle Runner in place using two of the 3.5" Hex Bolts. |
|
|
|
STEP 12
While the rocker is upside down, tighten all the nuts and bolts you can.
STEP 13
Turn the Rocker in its original position and tighten the remaining nuts and bolts.
STEP 14
Insert the drink holder cups and attach the head pillow(S).
Care Instruction and Tips:
Great care has been put into manufacturing this item. However, it is made of high density resin and some natural esthetic imperfections and dark spots are normal and should be expected. You can wash the wood and the rope using a hose and some bleach water. You can also brush the wood to help remove dirt.
*These instructions are also available at www.nagsheadhammocks.com/nhdwr.asp |
